2-2 CHAPTER 2: INSTALLING THE HARDWARE
Inspecting the Adapter
Before installing the adapter in your computer, you should
visually inspect it for damage that might have occurred
during shipment from the factory.
CAUTION: Each adapter is packed in an antistatic container to
protect it during shipment. To avoid damaging any static-
sensitive components after removal from the container, be sure to
reduce any static electricity on your person. One way to do this is
to touch the metal chassis of your computer. You can maintain
grounding by wearing a wrist strap attached to the chassis.
1 Open the shipping container and carefully remove its contents.
The package should contain the following items:
■ 3Com Fast EtherLink Parallel Tasking EISA 10/100BASE-T
adapter
■ Fast EtherLink Parallel Tasking EISA 10/100BASE-T Network
Adapter User Guide
■ 3C59X EtherDisk diskette
2 Verify that you have received all items listed above, and
inspect each item for damage.
If you find any omissions or damage, contact your network
supplier and the carrier that delivered the package.
Installing the Boot PROM
The boot PROM is optional and can be purchased separately. If
you are installing it onto the adapter, follow the instructions
that accompanied the boot PROM.
Inserting the Fast EtherLink EISA Adapter
To insert the adapter into the computer, follow these steps:
1 Unplug the computer and disconnect all cables that are
connected to the main system unit.
