Setup Using Windows NT 3.5.1 RAS 3-17
6 Check Show All Devices.
7 Select 3ComImpact IQ for baud rates of up to 115.2Kbps
and click Next.
The 3C882 ISDN modem allows for transfer rates of up to
230.4 Kbps. However, some computers require the installation
of additional hardware, such as an accelerated serial port
card, to take advantage of this higher speed. Additional
configuration steps, as well, are required. Refer to “Setup for
230Kbps” for instructions.
8 Click OK.
This completes the setup procedure for Windows 95. Refer to
“Configure Dial-Up Networking” to setup a remote access
configuration, or continue on to Chapter 5, “Advanced
Configuration,” to review the default settings and ensure that
they reflect your preferences. If you prefer not to change the
default settings, then go on to Chapter 7, “Placing and
Receiving Calls”.
Setup Using Windows NT 3.5.1 RAS
This section describes how to set up the 3C882 ISDN modem
using Windows NT RAS version 3.5.1. Note that these
instructions assume that the 3C882 ISDN modem software
has already been installed.
1 Using the File Manager, locate the Windows NT
MODEM.INF file in the %SystemRoot%/System32/RAS
directory and rename it MODEM.ORG.
For example, if your root directory is Windows, you would
look for the Windows NT MODEM.INF file in the following
directory:
C:\windows\System32\RAS
