User Command Specifications
9．Details of command GET HPOS/VPOS
GET HPOS/VPOS
GET HPOS/VPOS
Horizontal position adjustment inquiry Vertical position adjustment inquiry
GET□HPOS GET□
POS
?△HPOS ?△
POS
:HPOS=<Horizontal position ad
ustment value: Number>
:VPOS=<Vertical position ad
ustment value: Number>
For all other responses, refer to "Error List."
-1
A "busy" response is given while the zoom or focus lens is being driven.
（Refer to the ZCONTDRV command and FCONTDRV command.）
With some input signals, it may not be possible to make this inquiry.
-2
> GET VPOS or ? VPOS
< g:VPOS=8
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command State
OFF ON PM
× ○ ×
× ○ ×
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
X600
SX60
××○ ×××××
SX6
× ○○
–×○ ×
SX50
× ○○
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
Model Power
Input Mode
Remote Local
Number
This inquiry can be made when the projector is in both the remote mode and power-on status at
the same time.
○○○○
These inquire about the current horizontal and vertical position adjustment values.
01.00** 01.01** 01.01** 01.01**
Commands
Function
Format
Description
Response
Horizontal and vertical position adjustment inquirie
Mode Control Setting Reference
×××–
Command
supported
The horizontal and vertical position adjustments can be set using the HPOS and VPOS commands,
respectively.
Example
SX60 X600SX50 SX6
PAGE 79
