E-40
Creating a User Tone
Use the following procedure to select a preset tone and change
its parameters to create a user tone.
1. First, select the preset tone you want to use as a
basis for your user tone.
2. Press the SYNTH button.
• This enters the Synth Mode, which is indicated by the
indicator next to SYNTH on the display screen.
3. Use [̇] and [̈] (CURSOR) to display the pa-
rameter whose setting you want to change.
• Each press of [̇] or [̈] (CURSOR) changes to the
next parameter. See “Parameters and Their Settings”
on this page for information on setting range for each
parameter.
4. Use [+] and [–] to change the setting of the cur-
rently selected parameter.
• You can also use the number buttons to input a value
to change a parameter setting. See “Parameters and
Their Settings” on this page for information on set-
ting range for each parameter.
5. After you are finished editing the sound, press
the SYNTH button to exit the Synthesizer Mode.
❚
NOTE
• See “Storing a User Tone In Memory” on page E-42 for details
on saving user tone data to memory so it is not deleted.
703A-E-042A
Currently selected parameter
Parameter setting value
A t k T i me
V i b D e l a
y
A t k T i me
R e l . T i m e
V i b . T
y
p
e
Parameters and Their Settings
The following describes the function of each parameter and
provides it’s set range.
■
Attack Time (Range: –64 to 00 to +63)
Time it takes before the tone sounds after a key is pressed
■
Release Time (Range: –64 to 00 to +63)
Time the tone continues to sound after a key is released
■
Vibrato Type (Vibrato Waveform)
(Range: See below.)
Specifies the vibrato type (waveform).
■
Vibrato Delay (Range: –64 to 00 to +63)
Specifies the amount of time before vibrato starts.
Value Meaning Waveform
Sin Sine Wave
tri Triangle Wave
SAU Sawtooth Wave
Sqr Square Wave
V i b D e l a
y
[̇]/[̈] CURSOR
SYNTH
[+]/[–]
