E-55
703A-E-057A
To delete specific note data
1. Perform steps 1 and 2 under “To correct mis-
takes while step recording” above to display the
note you want to delete.
2. Press the [̄] (ENTER) button.
3. In response to the “Delete?” message that ap-
pears on the screen, press the YES button to de-
lete the displayed note.
Editing Memory Contents
After you record to keyboard memory, you can recall indi-
vidual notes and parameter settings (such as tone number)
and make any changes you want. This means you can cor-
rect misplayed notes, make changes in tone selections, etc.
The following types of data can be edited.
• Note intensity
• Notes
• Chords
• Tone numbers
• Rhythm number
• INTRO/ENDING 1 button, INTRO/ENDING 2 button,
VARIATION/FILL-IN 1 button, VARIATION/FILL-IN 2
button, SYNCRHO/FILL-IN NEXT button operations
To edit memory contents
1. Press the SONG MEMORY button three times to
enter step recording standby, and then use the
[+] and [–] buttons to select either 0 or 1 as the
song number.
2. Use the SONG MEMORY TRACK buttons to se-
lect the recorded track that you want to edit.
3. Press the [̇] (CURSOR) button to enter the ed-
iting mode.
• The REC indicator disappears from the display, and
the STEP indicator flashes.
Flash
S t e
p
R e c
4. Use the [̇] and [̈] (CURSOR) buttons to move
to the location in track where the note or pa-
rameter you want to change is located.
Note editing example
5. Make any changes in the value that you want.
• The actual procedures you use to change a parameter
depend on the type of data it contains. See “Editing
Techniques and Display Contents” on page E-56 for
details.
6. Repeat steps 4 and 5 to edit other parameters.
7. Press the START/STOP button to end editing
when you are finished.
❚
NOTE
• The only parameters that can be editted for Tracks 2 through 6
are notes and tone numbers.
• In the case of real-time recording, you later can change tone
numbers you specified while recording to Tracks 1 through 6 is
in progress.
• You can only change tone numbers that were originally set for
Tracks 2 through 6 using step recording.
• In the case of real-time recording, you later can change rhythm
numbers you specified while recording to Track 1 is in progress.
• You can only change rhythm numbers that were originally set
for Track 1 using step recording.
• You cannot use the edit procedure to add more data to a re-
cording.
• You cannot move portions of a recording to a different location
within the recording.
• Note lengths cannot be changed.
N o t e C 4
PitchVelocity
Parameter being
edited
