BT100-EU-EN V3.0 8/13
3
Meter Description
1.
Power
button: Power ON/OFF
2. R READ button:
Press R button to show the manually logged
readings.
Press R READ button again to stop reading.
3. M MEMORY button:
Under the manual logging mode, the tester
stores a single set of logged readings to the
memory by pressing
M MEMORY button.
Press and hold M MEMORY button for 2
seconds to enter continuous (automatic) logging
mode. Press again to stop logging.
4. V-RANGE button: Select the voltage range. (4V,
40V)
5. HOLD button:
Press HOLD to freeze or unfreeze the displayed
reading.
Press and hold the HOLD button for 2 seconds
to enter the interval time (sample rate) setting for
continuous data logging.
6. Ω - RANGE button: Select the resistance range.
(40m, 400m, 4, 40)
7. REL button:
Press to move the cursor to the right.
Press REL (Relative) to zero the reading.
8. button: Press to increase the displayed value.
9. SET button:
Press SET to switch the comparator mode on or off.
Press and hold the SET button for 2 seconds to enter the comparator-setting mode. Press
again to store the setting in memory.
10. button: Press to decrease the displayed value.
11.
Button:
Press to move the cursor to the left.
Press
to switch the audible tone on or off.
12. RS-232 connector: PC interface connector.
13. – Input jack: Black test lead plug connection.
14. + Input jack: Red test lead plug connection.
15. LCD display (LED test status indicators are located below the LCD display)
16. AC adaptor input
