BT100-EU-EN V3.0 8/13
4
Display Description
1. Measured resistance reading (or High/Low resistance limit when setting up the comparator)
2. Measured voltage reading (or High/Low voltage limit when setting up the comparator)
3. The comparator set number (there are 99 sets total)
4. The memory location for manually logged data.
Symbols:
m: Milliohm (resistance)
V: Voltage
HOLD : Hold function (display freeze)
COMP : Comparator function enabled
: Low-Battery
:
Beeper enabled
DATA R : Manual datalogging enabled
M : Continuous datalogging enabled (flashes each time data is stored)
INTV: Interval time setting for the continuous datalogging function. (1 to 255 seconds)
COMP.SET : Comparator settings mode
HIGH: High limit setting (threshold) for the comparator
LOW: Low limit setting (threshold) for the comparator
LED Test Status Indicators
PASS (green LED): Battery is good (within the tolerances of the comparator’s preset limits)
WARNING (yellow LED): Battery is beginning to deteriorate
FAIL (red LED): Battery has failed
The LED status indications listed above are active when the High/Low comparator limits for internal
resistance and the comparator threshold value for voltage are properly configured.
