BT100-EU-EN V3.0 8/13
9
Specifications
Resistance measurement method Four (4) terminal Kelvin connections
A/D conversion Dual slope
Displays Dual LCD for measurements and programming icons
Three (3) test status LEDs
Datalogger Sampling rate 1 to 255 seconds (interval time between logged readings)
Open-circuit terminal voltage 3.5Vpp max
Input over range “OL” display
Low battery indication
display
Test current fault detect “- - - -” display
Auto power off After approximately 30 minutes
Zero (Relative) function Circuit offset voltage is displayed as 0V
Hold function Display freezes
Audible Alarm function Audible alert for Warning and Failure conditions (can be set
ON or OFF)
Comparator settings Resistance High/Low limits and Voltage threshold point
Number of comparator configurations 99 sets
Comparator output Test status LEDs for Pass (green), Warning (yellow), and Fail
(red) results (audible tone for Warning and Fail conditions)
Resistance
Voltage
Lo IN Hi
Lo Warning Warning Fail
Hi PASS Warning Fail
Manual Datalogging memory 999 sets can be stored in meter’s internal memory
Continuous (automatic) Datalogging 9600 sets can be stored in meter’s internal memory
Operating conditions 32 to 104°F (0
°
to 40
°C)
80%RH (non-condensing)
Storage conditions 14 to 122°F (-10
°
to 50
°C)
80%RH (non-condensing)
Power source Six (6) ‘AA’ 1.5V batteries; Optional 9V AC adaptor
Maximum power consumption 1.0VA
Maximum continuous operation 7 hours approx.
Altitude 2000m max.
Dimensions 9.8 x 3.9 x 1.7” (250 x 100 x 45mm)
Weight 1.1 lbs. (500g) approx. (including batteries)
Accessories Test Leads and batteries
Optional equipment AC adaptor (9V output)
