Control panel message Description Recommended action
Rotating...
belt drive
To exit press
Cancel Job key
The printer is executing aComponent
Test a
nd the component selected is
Belt Only.
Press CANCEL JOB when ready to stop this test.
Rotating...
fuser motor
To exit press
Cancel Job key
The printer is executing aComponent
Test and th
e component selected is
fuser motor.
Press CANCEL JOB when ready to stop this test.
Rotating...
transfer motors
To exit press
Cancel Job key
The printer is executing aComponent
Test and the comp
onent selected is
TRANSFER MOTORS.
Press CANCEL JOB when ready to stop this test.
Rotating
<color> Laser
Scanner
To exit press
Cancel Job key
A Scanner Test is in progress. Press CANCEL JOB when ready to stop this test.
Saving current state
The current state is being saved. No action necessary.
Setting saved
A menu selection has been saved. No action necessary.
Test terminated
A diagnostic test has been
terminated by pressing the C
ANCEL
JOB button.
No action necessary.
TRAY X CONTAINS
UNKNOWN MEDIA
The paper type in the specified tray
cannot be determined.
1. To change paper type, press .Use
and to highlight the type, then press
to select.
2. To change the paper size to Letter, A4,
Executive, B5 JIS, A5, or Legal, leave the
tray switch in the Standard position.
3. To change the paper size to other sizes,
move the tray switch to Custom, adjust the
paper guides against the paper, and close
the tray.
4. Use
and to highlight the paper size,
then press
to select.
TRAY X EMPTY
<TYPE> <SIZE>
alternates with
Ready
For menus press
The specified tray is empty and
needs to be filled, but the current
job does not need this tray to print
correctly.
Refill the tray at a convenient time.
TRAYXOPEN
For help press
alternates with
Ready
For menus press
The specified tray is open or not
closed completely. This tray is not
needed for the current print job.
Close the tray.
128 Chapter 8 Problemsolving EN_WW
