Hewlett-Packard 700 Manual

A SERVICE OF

next previous

Connecting to a 10BASE2 (ThinWire) Ethernet Network

Step 4:

ThinWire

Cables and

T-Connector

Connect the ThinWire network cables to the T-Connector and

then the T-connector to the DECXM transceiver as shown in

Figure 5–4.

Figure 5–4 Connecting the ThinWire Cables and T-Connector

to the DECXM Transceiver

MLO-011209

Step 5:

Terminate

Connection

If your workstation is the last one on a 10BASE2 (ThinWire)

network, you need to terminate the network connection. Do this

by connecting a terminator, rather than a ThinWire network

cable, to one side of the T-connector connected to the DECXM

Transceiver as shown in Figure 5–5.

5–10 Connecting Your System to a Network