18
the way down. Immediately press the pilot ignitor
minutes for air to clear the lines before the pilot will light.
immediately call your service technician or gas supplier.
11. Replace the inner and outer burner doors.
13. Set thermostat to desired setting.
DANGER:Hotwaterincreasestheriskof
scaldinjury.Consulttheinstructionmanual
beforechangingtemperature.
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
department.
C. Use only your hand to push down or turn the gas control
or explosion.
D. Do not use this appliance if any part has been under
to repair the unit! It must be replaced!
LIGHTING INSTRUCTIONS
1. Set thermostat to the lowest setting.
TO TURN OFF GAS TO APPLIANCE
BEFORELIGHTING:ENTIRESYSTEMMUSTBEFILLEDWITHWATERANDAIRPURGEDFROMALLFAUCETS.
A. This appliance has a pilot which is lit by a piezo electric
these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance
WHATTODOIFYOUSMELLGAS:
phone in your building.
GAS CONTROL
FIGURE “D”
TOP VIEW
1. STOP! Read the safety information
above on this label.
2. Set the thermostat to the lowest setting by turning
until it stops.
4. Remove the inner and outer burner doors located below
and behind the gas control unit.
which is used to light the pilot. Locate the ignitor on the
gas control.
8. The pilot is located on the right side of the burner. It can