22
2. CLOSE the cold water inlet valve to the water heater.
3. OPEN a nearby hot water faucet and leave open to allow for
draining.
4. Connect a hose to the drain valve and terminate to an
adequate drain.
NOTE:Ifthewaterheaterisgoingtobeshutdownand
drainedforanextendedperiod,thedrainvalveshouldbe
leftopenwithhoseconnectedallowingwatertoterminate
toanadequatedrain.
6. CLOSE the drain valve.
7. Follow instructions in the Filling The Water heater section.
8. Follow the lighting instructions in the Lighting section to restart
the water heater.
Service
Start Up Conditions
and Operational Conditions found in the Troubleshooting Guide
of this manual.
If a condition persists or you are uncertain about the operation of
1-800-4-MY-HOME
®
with a new one.
If the temperature-pressure relief valve on the appliance
Sears Service Center for further information. Do not plug the
temperature-pressure relief valve.
Draining
The water heater should be drained if being shut down
during freezing temperatures. Also periodic draining and