25
OperationalConditions(Continued)
LeakageCheckpoints
FIGURE 27.
A. Water at the draft hood is water vapor which has condensed
out of the combustion products. This is caused by a problem
in the vent. Contact the gas utility.
D. Small amounts of water from temperature-pressure relief valve
may be due to thermal expansion or high water pressure in
your area.
F. Water from a drain valve may be due to the valve being slightly
opened.
H. Combustion products contain water vapor which can
at the time of start-up after installation and when incoming
water is cold.
DO NOT replace the water heater until a full inspection of all
possible water sources is made and necessary corrective
Service and Adjustment section
threads and replace. Then follow Filling the Water Heater
instructions in the Installation Instructions section.