6
Required For This Page:
PB
PA
(1)
HD9139
(1)
7/16 Wrenches
Do not jam the poles
together until instructed.
TP
MP
Secure only finger
tight now.
Make sure the square
portion of the Bolt is
completely inside the
square hole.
PB
PA
PB
PA
Square holes
9A
8
MP
TP
Strike the pole on
the Wood Block
(AE) 5 to 6 times
on each end.
WARNING
Failure to seat the pole sections together
and secure the Carriage Bolts could
cause the pole sections to separate,
resulting in property damage or personal
injuries as listed on Page One.
HA
HC
HL
(2)
(2)
(2)
11
HA
HL
HA
RB
LB
HC
HC
Make sure the U-Bolt is in
the notches.
Completely tighten the Nuts (HA).
10
RB
LB
RF
RA
RE
RC
(2)
(2)
(2)
(2)
12
RA
RE
RC
RD
The Tap Bolts (RE)
should be at the outer
edge of the holes.
Tighten the T-Nuts (RA) only until the
Rubber Washers (RD) begin to bulge.
RD
HH01900B
HH01700C
Do not hit your
feet with the
pole, as serious
injury could
occur.
1/2 Wrenches
AE
RD
9B
83 5/8
WARNING
Do not overtighten the Cap Nut. If the
end of the Bolt breaks through the
plastic cap, call our Customer Service
Department at the number on Page
One. Exposed threads on the end of the
Bolt may cause serious injuries such as
those listed on Page One.
Completely tighten the Cap
Nut installed in Step 8.
Measure from the top of the
Top Pole to the bottom of
the Middle Pole. It must measure
83 5/8 or less. If it measures
longer than 83 5/8, strike it again on
the wood. If it is still too long, do not
complete assembly. Call our
Customer Service Department.
TP
MP
