18 www.pridemobility.com Jet 3 Ultra
Electrical Components
The electrical components are located on the power base. The ammeter and the charger power cord receptacle are
located on the right side of the power base. The main circuit breaker is located on the front of the battery tray. The
controller connector and the motor connectors are located on the power pod, inside the power base. See figure 7.
Ammeter: The ammeter displays the charger’s current output in amps. See VI. “Batteries and Charging.”
Charger Power Cord Receptacle: This is where the charger power cord plugs into the onboard charger. See VI
“Batteries and Charging.”
Main Circuit Breaker: The main circuit breaker is a safety feature built into your power chair. When the batteries and the
motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips to prevent damage to the motors and
the electronics. If the circuit trips, allow your power chair to “rest” for approximately one minute. Next, push in the circuit
breaker button, turn on the controller, and continue normal operation. If the main circuit breaker continues to trip repeat-
edly, contact your authorized Pride Provider.
Motor Connectors: This is where the controller connects to the motors. The motor connectors are color-coded with red
and yellow labels. The label color on the motor connector corresponds with the label color on the power pod.
Battery Connector: This is where the controller connects to the batteries.
Charger Inhibit Connector: The charger inhibit enables the onboard charger to disable the controller during charging.
See VII. “Operation.”
MOTOR CONNECTORS
ONBOARD
BATTERY
CHARGER
Figure 7. Jet 3 Ultra Electrical Components
III. YOUR POWER CHAIR
BATTERY CONNECTOR
JOYSTICK
MODULE
CONNECTOR
CHARGER
POWER CORD
RECEPTACLE
AMMETER
CHARGER INHIBIT
CONNECTOR
