Jet 3 Ultra www.pridemobility.com 33
VII. OPERATION
NOTE: The battery gauge will flash the “locked” sequence. 1 LED will flash on and then off. 2 LEDs will
flash on and then off. This sequence will continue until all five LEDs flash on and then off. The sequence will
continue until the power is turned off or until the controller is unlocked.
To unlock the controller:
1. Press the on/off button to turn on the controller. The battery condition meter will flash the “locked” sequence.
2. Move the joystick to the full forward position until it beeps.
3. Move the joystick to the full rearward position until it beeps.
4. Release the joystick. There will be one long beep. The controller system is now unlocked.
Sleep Mode
The power chair controller features a sleep mode. Sleep mode is a built-in circuit that will automatically shut off the main
power if the joystick is not moved in any direction for a period of time. This time factor is programmed into the controller.
To restore power and continue, push any button on the control panel.
Fault Codes
The battery condition meter will flash fault codes when the controller system detects an abnormal condition is the electrical
system. All of the battery condition meter LEDs will flash a number of times quickly, then pause, then flash again. The
battery condition meter will continue to flash the fault codes until the problem is fixed. The table below identifies the
individual fault codes. If any of these fault codes persist, contact your authorized Pride Provider.
Fault Code Probable Cause(s) Possible Solution
1 Flash The batteries need charging. Check the battery connections. If the battery
There is a bad connection to the batteries. connections are good, then try charging the
batteries.
2 Flashes There is a bad connection on the left motor. Check the left motor connections and wiring
harnesses.
3 Flashes The left motor has a short to a battery connection. Contact your authorized Pride Provider.
4 Flashes There is a bad connection on the right motor. Check the right motor connections and wiring
harnesses.
5 Flashes The right motor has a short to a battery connection. Contact your authorized Pride Provider.
Rippling LEDs The charge inhibit has been activated. Make sure that the battery charger is not
connected to the power base.
7 Flashes There is a joystick fault. Make sure the joystick is in the center position
and then power off and on again.
8 Flashes There is a control system fault. Check power module and joystick module
connections and wiring.
9 Flashes The park brakes have a bad connection. Check the left and right motor connections and
wiring.
10 Flashes An excessive voltage has been applied to Check the battery connections.
the control system.
