Jet 3 Ultra www.pridemobility.com 23
Figure 13. Seat Mounting Holes
V. COMFORT ADJUSTMENTS
10. Reinstall the retaining clips from step 8.
11. Remove each screw from the trapeze bars and apply thread
lock.
12. Reinstall each screw into the trapeze bars and tighten.
13. Reinstall the seat.
14. Reconnect the controller connectors to the power pod.
15. Reinstall the rear shroud and tighten the fasteners.
Seat Position
You can move the seat forward or rearward by changing
the extrusion mounting position.
To change the position:
1. Turn off the power to the controller.
2. Unplug the controller connectors from the power pod.
See figure 7.
3. Remove the seat from the power base. See figure 10.
4. Remove both extrusions from the bottom of the seat.
5. Reposition the extrusions on a different set of mount
ing holes. You must move both extrusions the same
number of holes either forward or backward. See
figure 13.
6. Fasten the extrusions back onto the bottom of the seat.
7. Reinstall the seat.
8. Plug the controller connectors into the power pod.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback,
you can adjust it to four (4) different angles: 90°, 102°,
105°, or 107°.
To adjust the seatback angle:
1. Remove the adjusting screws from each seat hinge.
2. Set the seatback at the desired angle. See figure 14.
3. Reinstall the adjusting screws to each seat hinge and
tighten.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat, you
can adjust the seatback angle with the seatback release
lever. The lever is located on the right side of the seat base.
See figure 14.
To adjust the recline angle:
1. Push down on the seatback release lever.
2. Lean forward or backward to the desired position.
3. Release the lever.
Figure 14. Manual Recline Seatback Adjustment
SEATBACK
RELEASE LEVER
