Retrotec Energy Innovations, Ltd.
33
DM-2A Mark II 2008-02-22
Section 5
Using Advanced Configuration
Modes
The DM-2A mark II gauge has several different pre-programmed test measurement mode
configurations that enable you to quickly calculate various measurements in the field.
Accessing Configuration Modes
By default, your gauge comes configured with a number of commonly used modes pre-
enabled. However, if you need to you can change the enabled modes or their displayed units
at any time. For example, to meet a specific requirement or preference you can display pressure
values in PSF instead of Pa. These types of configuration changes are simple and straightforward
to perform.
To quickly access and/or change measurement mode configurations, follow these brief steps:
1. Press the Setup button, select Mode Setup, and press enteR to view the Enable/Disable
Modes menu screen.
2. Navigate to select a mode in the list using the (Up) and/or (Down) keypad
buttons.
3. To cycle through the unit measurement types for available modes press the enteR,
(Up) and/or (Down) keypad buttons. Choosing Off disables the selected mode.
4. To change pressure values associated with specific modes press the enteR keypad
button, enter the pressure value, and press enteR again to apply the change.
5. Press the exit keypad button twice to return to the main menu.
For detailed steps on setting device modes, see Enabling and Disabling Devices in Section
2, Working with the Setup Screen.
DM-2A Mark II Dual-Channel Pressure Gauge User Manual
5: Advanced Modes
