GL-1010 Administrator’s Guide 155
INSTALLING GL-1010 WINDOWS PRINTER DRIVERS
Adding Printers in Windows
In most cases, it is probably easiest to install the Toshiba
GL-1010 drivers as part of the InstallShield client software setup
process. However, there are several situations in which it may be
necessary to add, re-install, or update missing or outdated
GL-1010 driver software.
You can install printer drivers in the following ways:
n Run the Setup Program.
Use the GL-1010-Client Setup Maintenance Program to
install selected drivers. This method is recommended if you
have the original or an updated e-STUDIO GL-1010 Client
CD-ROM or access to it on a network directory.
n Download Drivers from the GL-1010.
Drivers are automatically downloaded pointing to the shared
printer on the GL-1010 in a Microsoft Peer to Peer
environment. Similarly, if the GL-1010 has been set up as an
NDPS printer, the drivers configured for the selected Printer
Agent are automatically downloaded For details on setting up
NDPS printing, refer to
Setting Up Novell Printing on page 115.
While this method proves a simple and effective way to
install drivers, you risk installing outdated drivers if the
controller software has not been updated with the most recent
driver software. For instructions, refer to
Download Drivers
from the GL-1010 in the
GL-1010 Operator’s Guide (Basic).
n Install Drivers from Disk or Network Location.
You can use the Add Printer Wizard to install driver software
by locating the driver’s setup.inf file either on the e-STUDIO
GL-1010 Client CD-ROM or in a primed network directory.
This is the method you must use if printing to a Novell, IPP,
or LPD queue. Additionally, you must configure a Microsoft
port for the printer.
All of these procedures are described in detail in the GL-1010
Operator’s Guide (Basic).
