Filter
Top Products
Problem Solving
10
PROBLEM SOLVING
If you are experiencing difficulties with your installation, try the following.
• Ensure all networking equipment is switched on.
The Router should be showing a green Power LED. If it is not, check the
power adapter connection. Do not use any power adapter with your
Router other than the one supplied.
• Ensure that the computer is connected to the Router.
The Router should be displaying a green LAN Status LED. If it is not, verify
that the computer is connected to one of the Router’s LAN ports with an
Ethernet cable.
• Ensure that you do not have a Web proxy enabled on your computer.
Go to the Control Panel and click on Internet Options. Click the
Connections tab, and then click the LAN Settings button at the bottom.
Make sure that the Use Proxy Server option is unchecked.
• If you are unable to access the Router’s Web interface.
Launch a Web browser, and then enter http://192.168.1.1. If you chose a
different IP address, use that instead. Ensure that you include the http://
prefix.
• Ensure your computer is configured correctly.
Make sure that the computer obtains an IP address automatically from the
Router’s DHCP server.
• If you have an existing DSL line and have PPPoE client software installed
on your computer, you need to disable it.
• It is important that you set up the correct VPI/VCI parameters and
Encapsulation (LLC or VC Mux) method to match up with your DSL line.
These parameters can be obtained from your ISP.
• Check that the PPPoE/PPPoA settings are correct (for example, user name,
password and IP address configuration).
• You must use a splitter to separate the Router from your telephone. A
micro-filter can then be used in line with the telephone to ensure that the
Router and telephone do not interere with each other. Ensure that a
microfilter is not fitted directly inline with the Router.
DSL Internet
Connections