Filter
Top Products
Positioning and Installing Your Router
4
1. POSITIONING AND INSTALLING YOUR ROUTER
WARNING: Please read the ‘Important Safety Information’ section in
the Support and Safety Information sheet before you start.
VORSICHT: Bitte lesen Sie den Abschnitt „Wichtige
Sicherheitsinformationen” sorgfältig durch, bevor Sie das Gerät in
Betrieb nehmen.
AVERTISSEMENT: Lisez attentivement le paragraphe “Remarques
relatives à la sécurité” avant de mettre votre routeur sous tension.
When positioning your Router, ensure that:
• The Router is centrally located to the wireless computers that will connect
to it. A suitable location might be on top of a high shelf or similar furni-
ture to optimize wireless connections to computers in both horizontal and
vertical directions, allowing coverage throughout.
• It is out of direct sunlight and away from sources of heat.
• Cabling is away from power lines, fluorescent lighting fixtures, and
sources of electrical noise such as radios, transmitters and broadband
amplifiers.
• To meet FCC radiation exposure regulations, the Router should be located
in a position that maintains a minimum distance of 20 cm (8 inches) from
any personnel (refer to the User Guide for details).
• Water or moisture cannot enter the case of the unit.
• Air flow around the unit and through the vents on the side of the case is
not restricted. 3Com recommends that you provide a minimum of 25 mm
(1 in.) clearance.
Use the four self-adhesive rubber feet to prevent your Router from moving
around on your desk or when stacking with other flat top units. Only stick
the feet to the marked areas at each corner of the underside of your Router.
Using the Rubber Feet
Safety Information