Filter
Top Products
10
Inserting the memory card
The memory card contains the data and Handheld software
required for operation.
1 - Install a pull tab on the
memory card
The handheld includes a number of pull
tabs that you can attach to various memory
cards. These pull tabs can make removing
memory cards easier.
For reliable operation, 3M recommends
using only SanDisk memory cards and
SanDisk memory-card readers.
2 – Insert the memory card
1 Grasp the memory card with the label
side up.
2 Push the pin-socket end of the memory
card into the memory-card slot until it
is completely inserted.
Messages (such as loading the
database, etc.) appear on the
screen.
If the memory card contains a
newer version of 3M software, a
dialog box will ask you if you want
to install the new version.
Above the memory-card slot is a Secure
Digital (SD) card slot that is not used. A
small plastic panel blocks the SD slot. If
the panel becomes loose, push it back
into place.
Database Errors
The handheld may display No Database or
Invalid Database messages.
These messages are usually the result
of corrupted data on the memory card.
If you see these messages, you may
have to reformat the memory card
(See Formatting a memory card
on
page 13.)
CompactFlash
32
MB
702_00
7
78-8123-7890-5
Memory Card
Pull Tab
Pin Socket
CompactFlash
32
MB
78-8123-7890-5
Figure 3: Attach the memory-card pull tab to the
memory card.
Pin-socket side of
the memory card
702_008
Insert the memory card with:
>
The pin-socket end of
the memory card facing
the Handheld
> The label facing up.
Figure 4: Insert the memory card as shown.