Filter
Top Products
60
♦ AUTOPAN LINE
There are four sets of auto-pan lines built in speed dome camera. Users are
able to command the speed dome camera to do continuously panning without
limit by setting the start point the same as endpoint.
♦ START POINT
Follow the description to set the start position of the AUTOPAN path.
1. Move the cursor to <START POINT> and press <ENTER> while <TO
FIND> item flashes, the item will turn <TO SAVE> automatically.
2. Move the speed dome to a desired position and press <ENTER> to save
the position as the start point; the cursor will move to <END POINT>
automatically. Ensure to set the end point to complete the auto-pan
setting.
♦ END POINT
Users are able to set the end point after the start point is defined. Pan the
dome to another position and press <ENTER> to save the position as the end
point.
♦ DIRECTION
The item is for setting the AUTOPAN direction of speed dome camera. The
speed will start to pan clockwise from the start point to the end point if your
selection is <RIGHT>, and then return to the start point. The speed dome will
start to pan anti-clockwise from the start point to the end point if your
selection is <LEFT>. Refer to below diagram.
NOTE: The tilt and zoom value of the start point will be
recorded and fixed for the selected auto-pan line.
AUTOPAN
AUTOPAN LINE 1
START POINT TO FIND
END POINT
TO FIND
DIRECTION RIGHT
SPEED 1
RUN AUTOPAN ENTER
EXIT YES