Agilent Technologies E3632A Welding System User Manual


 
Chapter 2 Initial Operation
Output Checkout
31
2
6
Ensure that the current can be adjusted from zero to the full rated
value.
Adjust the knob until the ammeter indicates 0 amps and then until the ammeter
indicates 7.0 amps.
1
Note
If an error has been detected during the output checkout procedures, the
ERROR annunciator will turn on. See "Error Messages" for more information
starting on page 121 in chapter 5.
1
You can use the resolution selection keys to move the blinking digit the right
or left when setting the current.