Filter
Top Products
Chapter 5 339
One-Button Measurement Functions
Mode Setup (Spectrum Analysis Mode)
One-Button Measurement Functions
Example: RAD:STAN WL802DOT11A
5.3.1.14.2 802.11b Sets the specific parameters for the selected measurement (located
under the
“MEASURE (Spectrum Analysis Mode)” key description) appropriate for industry
standard 802.11b. This standard is only available for the Spectrum Emission Mask (SEM)
measurement.
Key Type: 1 of N menu
Key Path:
Mode Setup, Radio Std
History: Modified with PSA firmware revision A.04.00
Added with PSA firmware revision A.03.00
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect]
See “Radio Std” on page 333.
Example: RAD:STAN WL802DOT11B
5.3.1.14.3 802.11g Sets the specific parameters for the selected measurement (located
under the
“MEASURE (Spectrum Analysis Mode)” key description) appropriate for industry
standard 802.11g. This standard is only available for the Spectrum Emission Mask (SEM)
measurement.
Key Type: 1 of N menu
Key Path:
Mode Setup, Radio Std
History: Added with PSA firmware revision A.04.00
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect]
See “Radio Std” on page 333.
Example: RAD:STAN WL802DOT11G
5.3.1.14.4 Hiper LAN/2 Sets the specific parameters for the selected measurement
(located under the
“MEASURE (Spectrum Analysis Mode)” key description) appropriate for
industry standard Hiper LAN2. This standard is only available for the Spectrum Emission
Mask (SEM) measurement.
Key Type: 1 of N menu
Key Path:
Mode Setup, Radio Std
History: Added with PSA firmware revision A.03.00
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect]
See “Radio Std” on page 333.