Filter
Top Products
Page 16 AMERICAN SANDERS TECHNOLOGY Apollo 8 Operator's Manual
Sanding Adjustment Procedures (CONT)
To decrease the travel or reduce the reach on the
grip control follow this procedure:
1. Hold the control rod and loosen the locknut. See
figure #16.
2. Screw the control rod out until desired reach is
found.
3. Hold the control rod and tighten the locknut.
Routine Maintenance
The following items need to be periodically inspected
and maintained to keep your sander in good working
condition.
Sanding Chamber
Periodically blow out the sanding chamber to prevent
large accumulations od 1prhiswhiachcouoldaintrferet
the enstiol rllern.