Filter
Top Products
Page 12 For technical questions, please call 1-800-444-3353. SKU 68001
NOTICE
Clean the Sprayer IMMEDIATELY after use. Delayed or inadequate cleaning will permanently clog the
Spray Gun. Warranty void if sprayer is not properly cleaned immediately after every use.
Priming Spray Gun
This procedure is used for rst time operation and also to
ush storage uids out of the Sprayer.
Priming Water-Based vs. Oil-Based Paints
Oil-based Paint:
Flush with mineral spirits followed by warm clean water.
WARNING! TO PREVENT FIRE:
When using mineral spirits, ground gun by holding
it against a metal container while ushing.
Water-based (Latex) Paint:
Flush with warm clean water.
Priming and Startup Steps
1. Separate smaller Return Tube from Suction Tube.
2. Place Return Tube in waste bucket.
3. Submerge Suction Tube in water or ushing solvent.
4. Turn Prime/Spray switch to Prime mode.
5. Plug in Sprayer and turn on power.
6. Adjust Pressure Control Knob to Prime/Clean setting.
Hi Spray Low Spray Prime/Clean Roll
7. Sprayer will start pumping and water or ushing solvent
as well as air bubbles will be purged from system.
Let uids discharge from Return Tube into waste
bucket for 30 to 60 seconds then switch Power to Off.