Filter
Top Products
Page 13For technical questions, please call 1-800-444-3353.SKU 68001
NOTICE
Clean the Sprayer IMMEDIATELY after use. Delayed or inadequate cleaning will permanently clog the
Spray Gun. Warranty void if sprayer is not properly cleaned immediately after every use.
8. Remove Suction Tube from water or ushing
solvent and submerge in paint pail.
9. Switch Power to On.
10. Paint should work itself from Suction Tube to Sprayer to
Return Tube until paint discharges from Return Tube.
Point gun into waste bucket and pull trigger.
11. Turn Spray/Prime Switch to Spray mode and
continue to spray into waste bucket.
12. Stop spraying and activate trigger lock.
13. Remove the Return Tube from the waste bucket and
clip to Suction Tube and submerge in paint pail.
14. If the motor stops, the pump and tubes are primed.
If it does not stop, repeat priming steps.
15. Start Painting.