Filter
Top Products
M-GAGE
®
S18M — Vehicle Detection Sensor
6 P/N 114430 rev. A
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
P/N 114430 rev. A 7
M-GAGE
®
S18M — Vehicle Detection Sensor
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Specifications
Dimensions
Cabled Model Quick-Disconnect Model
Supply Voltage
10 to 30V dc (10% max. ripple) at 43 mA, exclusive of load
Above +50°C, supply voltage is 10 to 24V dc (10% max. ripple)
Sensing Range
See Figures 5 and 6.
Sensing Technology
Passive 3-axis magnetoresistive transducer
Supply Protection Circuitry
Protected against reverse polarity and transient voltages
Output Configuration
Two SPST solid-state outputs conduct when object is sensed; one NPN (current sinking) and one PNP (current
sourcing)
Output Protection
Protected against short-circuit conditions
Output Ratings
10 mA maximum (each output)
NPN saturation: < 200 mV @ 10 mA and < 600 mV @100 mA; OFF-state leakage current: < 200 microamps
PNP saturation: < 1.2V @ 10 mA and < 1.6V @100 mA; OFF-state leakage current: < 5 microamps
Output Response Time
20 milliseconds
Delay at Power-Up
0.5 seconds
Temperature Effect
< 0.5 milligauss/ °C
Adjustments
Configuration of Background Condition and Sensitivity Level may be set using the sensor’s push button or
remotely via the portable programming box (see page 5)
Indicators Two indicators (see Figure 4 and instructions on page 5):
Power Indicator (Green)
Configuration/Output Indicator (Red/Yellow)
Remote TEACH Input
Impedance 12K ohms
Construction Threaded Barrel: Thermoplastic polyester Push Button Housing: ABS/PC
Push Button: Santoprene Lightpipes: Acrylic
Operating Conditions
-40° to +70° C (-40° to +158° F); 100% max. rel. humidity
Connections
2 m or 9 m shielded 5-conductor (with drain) PVC jacketed attached cable or 5-pin Euro-style quick-disconnect
(see page 8 for quick-disconnect cable options)
Environmental rating
Leak proof design is rated IEC IP67; NEMA 6P
Vibration and Mechanical
Shock
All models meet Mil. Std. 202F requirements method 201A (vibration: 10 to 60Hz max., double amplitude 0.06",
maximum acceleration 10G). Also meets IEC 947-5-2: 30G 11 ms duration, half sine wave.