Filter
Top Products
MatrixPRO • 8x8 DVI Router • User’s Guide 37
4. Operation
Using the Main Menu
opJOPO=pÉííáåÖë=jÉåì
From the System Menu, select RS-232 Settings to display the RS-232 Settings Menu.
This menu enables you to adjust the settings of the rear panel’s Serial Port.
Figure 4-6. MatrixPRO RS-232 Settings Menu
Please note:
• Baud rate choices are: 2400, 4800, 9600, 19200, 38400, 57600, and 115200.
• Parameters are fixed at N81 (one start bit, eight data bits, one stop bit and no
parity bit), and cannot be adjusted.
To change the RS-232 port’s baud rate:
1. On the RS-232 Settings Menu, press
SEL.
2. Rotate the knob to select the desired baud rate.
3. Press
SEL to accept the new value.
ae`m
On the System Menu, the DHCP function allows you to enable or disable DHCP.
• When enabled, the router’s IP address and subnet mask are set by your network’s
DHCP server, and cannot be changed locally. Use this setting when connected to
an external controller, such as Encore.
• When disabled, the system’s static IP address and subnet mask are active, and
can be changed locally.
To change the DHCP setting:
1. On the System Menu, scroll to the DHCP line and press
SEL.
2. Rotate the knob to select the desired setting (on or off).
3. Press
SEL to accept the new setting.
fm=^ÇÇêÉëë
From the System Menu, select IP Address to display the IP Address Menu.
Figure 4-7. MatrixPRO IP Address Menu
When this menu item is selected (and DHCP is off), the cursor (^) is positioned under the
right-most digit in the address.
RS-232 SETTINGS
> Baud Rate 115200
Parameters [N81]
IP ADDRESS
192.168.000.243
^