Filter
Top Products
MatrixPRO • 8x8 DVI Router • User’s Guide 39
4. Operation
Using the Main Menu
c~Åíçêó=oÉëÉí=jÉåì
From the Setup Menu, select Factory Reset to display the Factory Reset Menu.
Figure 4-9. MatrixPRO Factory Reset Menu
When you perform a factory reset, the following actions occur:
• All output channels are blanked, and all routes are cancelled.
• The serial communications baud rate returns to 115200.
• Vertical interval switching is set to “Disabled.”
• The IP address is set to the default value of 192.168.000.243.
• The Subnet Mask is reset to the default value of 255.255.255.000.
• DHCP is set to Off.
• EDID resolution is reprogrammed to the default value of 1400x1050 @59.94.
• All “preset” configuration files are cleared.
• The test pattern is reset to the default H Ramp type, and the default output
resolution of 1400x1050 @59.94.
To perform a factory reset:
1. From the Setup Menu, select Factory Reset.
2. On the Factory Reset Menu, select the desired function:
~ Press SEL to perform a factory reset. A confirmation message is shown,
and the system is rebooted.
~ Press ESC to return safely to the previous menu.
qÉÅÜ=pìééçêí=jÉåì
From the Setup Menu, select Tech Support to display the Tech Support Menu:
Figure 4-10. MatrixPRO Tech Support Menu
The Tech Support Menu shows the installed version of software, as well as the phone
number for factory support. In Appendix C, refer to the “Contact Information
” section on
page 102 for additional information.
FACTORY RESET
<SEL> = Yes
<ESC> = No
TECH SUPPORT
Version #.##
Ph: +1 866 374-7878