Filter
Top Products
7
CARTON CONTENTS
1. Miter Saw
2. Dust Bag
3. Clamp
4. 5mm Hex Wrench
5. 1/8” Hex Wrench
6. 1/2” Blade Wrench
1
2
4
6
Lifting the miter saw by the switch handle can cause misalignment. Always lift the machine by
the base or the carrying handle.
ASSEMBLY
For your own safety, do not connect the
machine to the power source until the machine is
completely assembled, and you read and understand
the entire instruction manual.
Fig. 1 Fig. 2
3
Remove the miter saw and all loose items from the carton.
ROTATING TABLE
Loosen the table-lock handle one or two turns. Raise the index
lever (B) Fig. 3 and rotate the table to the desired position.
Tighten the table-lock handle (A) Fig. 3.
B
A
Fig. 3
MOVING CUTTINGHEAD TO THE UP POSITION
1. Push down on the cuttinghead and pull out the
cuttinghead lock knob (A) Fig. 4.
2. Move the cuttinghead to the up position.
A
Fig. 4
ASSEMBLY TOOLS REQUIRED
(Supplied)
* 5mm hex wrench
* 1/8” hex wrench
* 1/2” blade wrench
(Not supplied)
* Phillips head screwdriver
* A square to make adjustments
5