Filter
Top Products
8-:)<176
#<):<16/)6,#<78816/
$
7:-,=+-<0-:1;37.-4-+<:7+=<1763--8
)44+766-+<176;,:A)6,7..<0-/:7=6,7
67<<7=+084=/?1<0?-<0)6,;
$7:-,=+-<0-:1;37.-4-+<:1+;07+384=/
<14- ;)? 16<7 :7=6, )=4< 1:+=1<
6<-::=8<-:8:7<-+<-,7=<4-<764A.)
8:7<-+<-,7=<4-<1;67<)>)14)*4-=;-)87:<)*4-:-+-8<)+4-
?1<0*=14<168:7<-+<176.
$7:-,=+-<0-:1;37.-4-+<:1+;07+3
)4?)A; <-;< <7 5)3- ;=:- 1< 1;
.=6+<17616/8:78-:4A*-.7:-84=//16/<14-;)?16<7
8:7<-+<-,:-+-8<)+4-
Connect the unit to a power source with the correct voltage
and frequency (120V, 60Hz).
$7;<):<<0-;)? push the switch to “1” (ON) position
(Fig. 7).
$7;<78<0-;)? push the switch to “0” (OFF) position
(Fig. 7).
)316/)4)<=<
1.Adjust the top guard/splash hood to slightly higher than
the workpiece and tighten knob to secure.
2.Adjust the parallel rip fence to the desired distance from
the tile blade, using the scale rules on the table surface
for reference. Tighten the fence-locking knobs on each
side to firmly lock the parallel rip fence on the table.
(Fig. 8)
3.Place the work piece against the parallel rip fence, and
feed the tile into the tile blade with a steady even
pressure (forcing the tile will cause the blade to slow
which could cause motor overheating). (Fig. 9)
4.Turn saw off when cutting is complete.
->-:84)+-A7=:0)6,7:.16/-:;16<0-
8)<07.<0-<14-*4),-
FIG. 7
FIG. 9
FIG. 8
7+316/67*
#+)4-"=4-
-6+-
WARNING
!
WARNING
!
WARNING
!
DANGER
!
SM_2610008271_12-09:tile saw 12/17/09 3:25 PM Page 13