Filter
Top Products
8-:)<176
)316/)1<-:=<
1
.Adjust the parallel rip fence to the desired distance from
the tile blade, using the scale rules on the table surface
for reference. Tighten the fence-locking knobs on each
s
ide to firmly lock the parallel rip fence on the table.
(Fig. 8)
2.Use the angle guide supplied in conjunction with the
parallel rip fence.
3.Select the desired angle and tighten the screw to secure
the angle guide (Fig. 10).
4.Place the tile against the angle guide. (Fig. 10).
5.Hold the tile firmly against the angle guide and feed it
slowly toward the rotating tile blade.
)316/)->-4=<
1.Loosen the bevel cutting knobs on both sides of the table
(Fig. 11).
2.Tilt the table to the desired angle, using the scale for
reference.
3.Tighten the bevel cutting knobs.
4.Follow the instructions for making a flat cut (Fig. 12).
$7)>71,87;;1*4-162=:A<0-:18.-6+-
;07=4,764A*-=;-,76<0-:1/0<;1,-7.
<0-<)*4-?014-5)316/)*->-4+=<
.<-:%;-
• Verify the ON/OFF switch is in the OFF position.
• Unplug the tile saw from the power source.
• Clean the tile saw after each use.
• Emtpy and clean water trough.
• Wipe off all exterior surfaces and tile blade.
FIG. 10
FIG. 11
FIG. 12
->-4
67*
6/4-
=1,-
67*
6/4-
=1,-
WARNING
!
SM_2610008271_12-09:tile saw 12/17/09 3:25 PM Page 14