Filter
Top Products
)16<-6)6+-
For your own safety, turn switch “OFF” and
r
emove plug from power source outlet be -
fore maintaining or lubricating your saw.
The cord and the tool should be wiped with a dry clean
cloth to prevent deterioration from oil and grease.
Certain cleaning agents and solvents can
damage plastic parts. Some of these are:
gasoline, carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents which contain
am monia. Avoiding use of these and other types of cleaning
agents will minimize the possibility of damage.
A coat of automobile-type wax applied to the table will help
to keep the surface clean and allow workpieces to slide
more freely.
If the power cord is worn or cut, or damaged in any way,
have it replaced immediately.
All repairs, electrical or mechanical, should
be attempted only by trained repairmen.
Contact the nearest Factory Service Center or Authorized
Service Station or other competent repair service. Use only
identical replacement parts, any other may create a hazard.
++-;;7:1-;
Use only recommended accessories. Follow
instructions that accompany accessories.
Use of improper accessories may cause hazards.
)16<)1616/(7=:$14-#)?
WARNING
!
WARNING
!
WARNING
!
WARNING
!
$:7=*4-;077<16/
$=:6;?1<+0HI)6,)4?)A;:-57>-84=/.:75<0-87?-:;7=:+-*-.7:-<:7=*4-;077<16/
$"% " "(
'14467<;<):<
Power cord is not plugged in. Plug in.
Fuse or circuit breaker tripped. Replace fuse or reset tripped circuit breaker.
Cord damaged.
Have cord replaced by an Authorized Skil Service Center
or Service Station.
Burned out switch.
Have switch replaced by an Authorized Skil Service Center
or Service Station.
7-;67<+75-
=8<7;8--,
Extension cord too light or too long. Replace with adequate cord.
Low house voltage. Contact your electric company.
@+-;;1>->1*:)<176
Tile blade out of balance. Discard tile blade and use different one, see page 11.
Tile blade bolt not tight. See “Tile Blade Installation”, page 11.
WARNING
!
SM_2610008271_12-09:tile saw 12/17/09 3:25 PM Page 15