Filter
Top Products
30.
Changing The Blade
To prevent personal injury, always disconnect
plug from power source before changing blades.
1. Turn elevation wheel clockwise until the blade is up as high as it
will go, remove table insert
1 using finger hole (Fig. 10).
2. Lift up arbor lock lever
2 and slowly rotate blade by hand until
lock fully engages saw arbor and stops rotation (Fig. 10). Loosen
arbor nut
3 counter clockwise with the arbor wrench 4 provided
(Fig. 11). Set wrench aside and continue to loosen arbor nut
3 by
hand and remove arbor nut
3 and outer washer 5. Blade may now
be removed or installed by sliding on or off arbor shaft
6.
3. Assemble inner washer
7 and new blade as shown in figure 12,
making certain the TEETH OF THE BLADE ARE POINTING
DOWN AT THE FRONT OF THE TABLE.
NOTE: The printing on different saw blades are not always on the
same side.
4. Assemble outer washer
5, arbor nut 3 as shown in figure 12.
While lifting up arbor lock lever
2 securely tighten arbor nut 3
clockwise with the wrench 4. (Fig. 11).
5. Position table insert in pocket of table so tabs
8 on table insert 1
are in slots in pocket of table and push down and secure in place.
Assembly
FIG. 11
FIG. 12
2
7
1
FIG. 10
8
3
4
5
WARNING
!
3
5
7
6