Filter
Top Products
5/16” HEX BOLT,
WASHER,
& HEX NUT
x4
6
FIG. 14
32.
If table saw is to be used in a permanent location, it should be
fastened securely to a firm supporting surface such as a stand or
workbench, using the four mounting holes
6 (Fig. 14).
1. If mounting to a workbench, the base should be bolted
securely using 5/16" hex bolts (not included) through mounting
holes
6 provided.
Hint: If workbench is 3/4” thick, bolts will have to be at least
3-1/2” long - if workbench is 1-1/2” thick, bolts should be at
least 4-1/2” long.
2. Locate and mark where the saw is to be mounted, relative to
holes in the base of the tool.
3. Drill four (4) 3/8" diameter holes through workbench.
4. Place table saw on workbench aligning holes in base with
holes drilled in workbench.
5. Insert four (4) 5/16" dia. bolts through holes in base and
supporting surface; then secure with (4) 5/16” flat washers and
(4) 5/16" hex nuts.
Attaching Rip Fence
1. Raise rip fence handle 1, so holding clamp 2 is out far enough to
fit on the table
3 and into “V” groove located on the back of rear rail
(Fig. 13).
2. Position the rip fence
4 over table 3 holding up the front
end, first engage holding clamp
2 with rear rail.
3. Lower front end onto front rail
5.
Mounting The
Table Saw
1
2
3
3
2
4
1
5
FIG. 13
Assembly