Filter
Top Products
24.
Microfine Miter Adjustment
System
This feature allows you to move the turntable by very
small increments up to 2 degrees to the left or right of
the detent angles (except 60° detent) to reach to the
desired miter angle.
1. Move the table to the detented angle that is to be
adjusted (Figure 1).
2. The miter detent lever's red override feature
MUST be engaged, as described above.
3.
Push the Microfine
Adjustment knob forward to
'ENGAGED' position. This engages the system
into the detent slot (Figure 2).
Note: You may have to rotate the table slightly to
engage the system.
4.
T
urn knob until pointer comes to desired angle.
•
Rotating the knob forward causes the table to
rotate to the left.
• Rotating the knob backward causes the table to
rotate to the right.
5.
Use miter lock knob to lock table in place before
cutting.
6. To release table from Microfine Adjustment
System, simply pull knob away from table until in
snaps into 'OFF' position.
NOTE: Microfine must be returned to the ‘OFF’
position in order to use the standard detent system.
OFF ENGAGED
Basic Saw Operations (continued)
Figure 2. Microfine Adjustment System
Figure 1. Miter Scale Indicator
Figure: Detent Override
Miter Detent Override
The miter detent override feature allows the detent
action to be locked out, allowing for micro adjust-
ments at any miter angle. When the desired miter
angle is to close to a standard mitering angle that has
a detent slot, this feature prevents the wedge on the
miter arm from slipping into the detent slot on the
base.
To Engage:
1. Lift and hold the miter detent lever.
2. Push the detent override clip forward and latch in
place over edge. Release miter detent lever.
3. Move miter arm to any position on the miter scale.
4. Lock the miter lock knob to retain miter position.
T
o Disengage:
Loosen miter lock knob and lift the miter detent lever
to release the detent override clip. The clip should
automatically disengage.
Miter
Lock Knob
Miter
Lock Knob
Microfine
Adjustment
knob
Detent
Override Clip
Miter
Detent Lever
10
5
0
5
15
20
25
85
0
80
30
35
75
70
65
60
55
22.5
31.6
85
Bevel Lock
60
55
50
45
35
30
40
Miter Scale
Indicator
Angle Detents