Bosch Power Tools GPL2 Laser Level User Manual


 
-5-
Use the tool, accessories, etc., in
accordance with these instructions and in
the manner intended for the particular type
of tool, taking into account the working
conditions and the work to be performed.
Use of the tool for operations different from
those intended could result in a hazardous
situation.
Service
Have your tool serviced by a qualified repair
person using only identical replacement
parts. This will ensure that the safety of the tool
is maintained.
Develop a periodic maintenance schedule
for tool. When cleaning a tool be careful not
to disassemble any portion of the tool since
internal wires may be misplaced or pinched
or may be improperly mounted. Certain
cleaning agents such as gasoline, carbon
tetrachloride, ammonia, etc. may damage
plastic parts.
The numbering of the product features shown
refers to the illustration of the tool on the
graphic page.
1 Exit opening for laser beam
2 Latch of battery lid
3 Battery lid
4 On/Off switch
5 Laser warning label
6 Tripod mount 1/4”
7 Serial number
8 Multiple-Purpose Attachment
9 Locking screw for Multi-Purpose
Attachment
10 Screw holes of Multi-Purpose
Attachment
11 Opening for strap attachment
12 Magnets
13 1/4” tripod mount on Multi-Purpose
Attachment
14 5/8” tripod mount on Multi-Purpose
Attachment
15 Laser Target*
16 Belt Pouch*
17 Laser viewing glasses*
18 Tripod*
*The accessories illustrated or described are
not included as standard delivery.
Features
Preparation
Inserting/Replacing the Battery
Alkaline batteries are recommended for
the tool.
To open the battery compartment 3, turn the
latch 2 in clockwise direction to position and
pull off the battery lid. Insert the batteries
provided.
When inserting, pay attention to the correct
polarity according to the representation on the
inside of the battery compartment.
Position the battery lid to the bottom of the
housing and then push it upward. To lock the
battery lid, turn the latch 2 in counterclockwise
direction to the position.
When the laser beams flash slowly during
operation,the batteries are low. When the
flashing begins, the tool can be operated for
approx. 8 h.
Always replace all batteries at the same time.
Only use batteries from one brand and with the
identical capacity.
Remove the batteries from
the tool when not using
it for extended periods. When storing for
extended periods, the batteries can corrode and
discharge themselves.
This tool is intended for accurate transfer of plumb point from floor to ceiling.
Intended Use
!
WARNING