Filter
Top Products
Operating Instructions and Parts Manual
www.chpower.com
6
Important Safety Information (Continued)
SPRAYING PRECAUTIONS
Do not spray flammable materials in vicinity of open flame
or near ignition sources including the compressor unit.
a. Do not smoke when spraying paint, insecticides, or other flammable
substances.
b. Use a face mask/respirator when spraying and spray in a well
ventilated area to prevent health and fire hazards.
c. Do not direct paint or other sprayed material at the compressor.
Locate compressor as far away from the spraying area as possible to
minimize overspray accumulation on the compressor.
d. WHEN SPRAYING OR CLEANING WITH SOLVENTS OR TOXIC CHEMICALS,
FOLLOW THE INSTRUCTIONS PROVIDED BY THE CHEMICAL
MANUFACTURER.
AIR SOURCE
Air compressors providing air to the tank should follow the requirements
established by the American National Standards Institute Standard
B19.3-1991; Safety Standard for Compressors for Process Industries. Contact your air
compressor manufacturer for information.
SERVICE
a. Release air pressure from air tank by pulling safety relief ring before servicing or
replacing parts.
b. Service must be performed only by qualified repair personnel.
Never attempt to repair or modify a tank! Welding, drilling or any other
modification will weaken the tank resulting in damage from rupture or
explosion. Always replace worn or damaged tanks.
c. When servicing a tool, use only identical replacement parts. Use only authorized
parts.
NOTE: The DANGER, WARNING, CAUTION, and NOTICE notifications and instructions
in this manual cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which cannot be built
into this product, but must be supplied by the operator.
SAVE THESE INSTRUCTIONS
DO NOT DISCARD