Filter
Top Products
1.
Outline
The Canon DCS (Digital Camera System) Adapter CR-DAI
is
for converting the size
of
the image
taken with our Non-Mydriatic Retinal Camera CR6-45NMlCR6-45NMf into a size to allow the image
to be taken with a Canon's EOS digital camera.
Please contact Canon representative or distributor for installation, preparation and adjustment
of
the
system using the CR-DAI.
2.
Notes
for
Using
the
Instrument
(1)
Before Photography
1)
Sudden heating
of
the room in cold areas will cause condensation to form on the objective lens or
optical parts inside the instrument. In this case, wait until condensation disappears before perform-
ing measurement.
(2)
During Photography
1)
Quality
of
image obtained with this system varies according to the general performance
of
the
instruments that are used.
Please consult Canon representative or distributor regarding the instrument to be used.
Also, please refer to the manuals
of
respective instruments for the procedure for operating them.
(3)
After Photography
1)
Tum OFF the power
of
the retinal camera and digital camera, and disconnect the cables prior to
removing the adapter from the retinal camera.
2) Dust will enter the adapter and the retinal camera when the adapter is left detached.
Also, dust on contact may cause contact failure.
Be sure
toput
the dust caps on both mounts and put the adapter in a vinyl bag or the like when it is
not going to be used for a long time.
(4)
During Cleaning
1)
Use a neutral detergent when you clean the cover
of
the adapter.
Never use a solvent such as alcohol, thinner or benzine. Otherwise, the cover may be corroded.
(5)
During Installation
1)
Handle the adapter carefully, as preadjustment may be altered
if
the instrument receives a strong
jolt.
-1-