Filter
Top Products
Page 4SKU 3663 For technical questions, please call 1-800-444-3353.
REV 04e, 04f, 07k
Use proper size and type extension cord17. . If an extension cord is required, it must be of the
proper size and type to supply the correct current to the tool without heating up. Otherwise, the
extension cord could melt and catch re, or cause electrical damage to the tool. This tool re-
quires use of an extension cord of 20 amps capability (up to 50 feet), with wire size rated at 12
AWG. Longer extension cords require larger size wire. If you are using the tool outdoors, use an
extension cord rated for outdoor use (signied by “WA” on the jacket).
Maintenance18. . For your safety, maintenance should be performed regularly by a qualied tech-
nician.
This product, when used for welding and similar applications, produces chemicals known to the 19.
State of California to cause cancer and birth defects (or other reproductive harm). (California
Health & Safety Code § 25249.5, et seq.)
The warnings, cautions, and instructions discussed in this instruction manual cannot cover all 20.
possible conditions and situations that may occur. It must be understood by the operator that
common sense and caution are factors which cannot be built into this product, but must be sup-
plied by the operator.
UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If any parts are
missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as
soon as possible.
ASSEMBLY
This step should only be performed by a licensed electrician. Acquire an appropriate 220 V~,
1-Phase plug to t in the electrical outlet. Connect the plug, making sure that the black wire is the ener-
gized (hot) lead, the white wire is the other energized (hot) lead, and the green wire is the ground lead.
See the wiring diagram on page 8.
FIGURE 1
Light
Annealing Button
Pressure Knob
Left Electrode
Left Hand Clamp
Power Cord
Light Switch
Welding Button
Right Electrode
Right Hand Clamp