Filter
Top Products
Page 7SKU 3663 For technical questions, please call 1-800-444-3353.
REV 04f
Annealing the Weld
Note: The annealing process tempers and toughens the blade, reducing brittleness.
Retighten the Right Hand Clamp (6). See Figure 7.1.
Press and hold the red Annealing Button (11) until the blade 2.
becomes dark red. Release the Annealing Button (11) after
a few seconds.
Repeat pressing and releasing (pulsating action) the An-3.
nealing Button (11) (while reducing the annealing time)
several times until the redness is no longer visible.
Let the saw blade cool for at least ve minutes, then unplug 4.
the plug and remove the blade from the Welder.
Use an 8 inch mill bastard le (not included) to le off the 5.
welding ash. If the ash is too hard and will not easily le
off, repeat the annealing process.
File all of the ashing from around the weld, being careful 6.
not to undercut the weld surface in comparison to the rest of
the blade.
Test the weld by carefully bending the blade to a 4 inch radius to see if it breaks.7.
Note: Test the repaired saw blade. After repairing the blade, carefully install it on the bandsaw fol-
lowing the instructions and safety warnings provided in the instruction manual of the bandsaw.
Once the blade is installed, make sure the guards and any cabinet doors on the tool are in the
closed/safe position. Run the saw for 2-3 minutes. Then, stop the saw, unplug it, and check the
weld visually before you begin cutting an actual workpiece. Do not continue if the weld shows
signs of cracking or breaking.
FIGURE 7