Filter
Top Products
SKU 42933 For technical questions, please call 1-800-444-3353. Page 11
secure them by partially tightening
the two screw clamps built into the
Base assembly.
Set the Arm (118) assembly column 6.
into the Column Base. Move the Arm
slightly to the left or right until the
column index knob locks into the arm
support column.
The arm support column has nine
positive stops: 0, 15, 30, 45, and 60°
(left and right).
7. Attach the Elevating Handle assem-
bly to the Arm using the Allen wrench
(provided).
8. Attach the Saw Blade (17) to the
Gear Shaft (19) and secure with the
Outside Flange (16) and Bolt (15).
Lock the Gear Shaft with the Stopper
Pin (22) located at the front part of
the Gear Case Cover (26).
Using a wrench, tighten the Bolt (15)
over the Outside Flange (16), coun-
terclockwise.
Place the Safety Guard (10) over the 9.
Saw Blade and tighten in place.
10. Install the anti-kickback pawl on the
Safety Guard (10) with the pawls fac-
ing the rear of the machine.
11. Set the height by loosening its lock
knob and moving it up or down. Re-
tighten again when set to the proper
height.
Verify that no play exists in the car-12.
riage, and that the arm, yoke, and
bevel locks and clamps are tight.
13. Slip the Dust Guide (4) over the
exhaust stem located on the Safety
Guard.