Filter
Top Products
SKU 42933 For technical questions, please call 1-800-444-3353. Page 12
OPERATING CONTROLS
Elevating Handle (88)
Yoke Pivot Clamp Handle (88)
Safety Guard (10)
Arm Index Knob (115)
Screw Clamp (137)
Switch (122) with Key (98)
Trigger
Bevel Index Knob (74)
Bevel Lock Knob (71)
Lock On Button
Safety Guard Lock Knob (5)
Anti-kickback Arm (13)
ON / OFF Switch – The Switch has a built-in
locking feature which requires a key to be
inserted before the saw can be turned ON.
Removing the Key and pushing the OFF but-
ton locks the saw against unintended use.
For crosscutting, press the green Switch in,
then squeeze and hold the Trigger. For rip
cutting, press the green Switch in, squeeze
the Trigger (motor starts), then push up on
the Lock On Button (for rip cutting only) to
keep the motor running without holding the
Trigger in. Depressing the Trigger again
will release the Lock On Button, turning the
motor off.
Carriage Lock – The Carriage Lock Knob
located on the left side of the Radial Arm,
permits the saw assembly to be moved
in or out, and locked at the desired posi-
tion on the arm. It must be fully released
for any crosscutting, and tightly locked for
all operations in which the saw assembly
is stationary. To lock turn clockwise. To
unlock turn counterclockwise.
Arm Angle – The Arm Index Knob (142)
and Washer (140) are located at the Col-
umn Base (132). They can index, release,