Filter
Top Products
Page 8SKU 67102 For technical questions, please call 1-800-444-3353.
surface with 80-grit sandpaper (not
included).
8.
plastic that requires elasticity, sand
area with 25-40 grit sandpaper.
Cut an appropriate-sized piece of 9.
the Reinforcing Mesh (3). Once the
corner of tab. Applying the mesh will
reinforce the plastic tab.
-10.
paper.
Melt appropriate-sized piece of Plas-11.
tic Stick into Mesh and use Welder
to spread plastic into cracks and
damaged area. Doing so will help
strengthen plastic.
To repair damaged plastic bolt hole 12.
or slot, use sandpaper to taper and
smooth broken edges. Apply alumi-
num tape (not included) to surround-
ing surface if desired.
-13.
ing edge around hole or slot. Apply
melted plastic to Mesh and allow to
cool.
Remove aluminum tape from hole 14.
and, if necessary, re-drill hole and
smooth with 80-grit sandpaper.
15.
Power Cord and set the Welder onto
the Welder Stand (4) and allow to
cool down.
Once cool, clean off welding tip using 16.
the Wire Brush (5) and then store Kit
indoors out of children’s reach.
MAINTENANCE AND
SERVICING
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION: Unplug the tool
from its electrical outlet and
allow to cool before
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVENT SERIOUS
INJURY FROM TOOL
FAILURE: Do not use
damaged equipment. If
abnormal noise or vibration
occurs, have the problem
corrected before further use.
Cleaning, Maintenance, and
Lubrication
BEFORE EACH USE,1. inspect the
general condition of the tool. Check
for loose screws, cracked or broken
parts, damaged electrical wiring, and
any other condition that may affect its
safe operation.
AFTER USE,2. clean external surfaces
of the tool with clean cloth.
3. WARNING! If the supply cord of
this power tool is damaged, it must
be replaced only by a qualied
service technician.
Always store Welding Kit in a clean, 4.
dry and safe location away from
children.