Filter
Top Products
SKU 67119 For technical questions, please call 1-800-444-3353. Page 12
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Tool Set Up
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool off and unplug the tool
from its electrical outlet
before preparing for
operation.
Installing Bits
Chip
Shield
(70)
Collet Nut (50)
Spindle Lock Button (46) Spindle
Figure 2
1. Unthread the Screw (85) holding the
Chip Shield (70) in place and remove
the Chip Shield.
Lock the Plunge Lock Lever (32) in 2.
place to keep the shaft stationary.
Depress the Spindle Lock Button (46) 3.
and rotate the Spindle until it locks in
place. Keep the Spindle Lock Button
depressed through step 6.
Use the Spanner Wrench (51) to 4.
loosen the Collet Nut (50).
Insert the bit all the way into the 5.
Collet. CAUTION! Bits are sharp,
Handle with care.
Securely tighten Collet Nut.6.
Release the Spindle Lock Button.7.
Pull up the Lock Lever to free the 8.
shaft.
Replace the Chip Shield.9.
Cutting Depth Adjustment
Depth
of Cut
Figure 3
Depth
Adjusting
Bolt (29)
Depth
Stop
Turret
(67)
Screw
(85)
Depth
Stop
Bar (30)
The depth of cut is equal to the dis-
tance between the lower end of the
Depth Adjusting Bolt (29) and the
section of the Depth Stop Turret (67)
directly below the Depth Stop Bar
(30). First, install the bit you will use
for the cut, then adjust the Router as
follows to set up the desired cutting
depth.