Filter
Top Products
SKU 91511 PAGE 12
3. Check to make sure the Blade Guard (2) moves freely upward and downward.
(See Figure D.)
4. Close the Left Side Cutting Table (26). (See Figure D.)
To Attach The Fence And Miter Guide:
1. Place the Fence (11) on top of the Right Cutting Table (10) and clamp both ends
of the Fence to secure it in place. The Fence is marked in both inches and centi
meters to make cuts accurate. The Fence may be used on either side of the Saw
Blade (6). (See Figure E.)
2. Slide the Miter Guide (24) into the Miter Guide Sliding Track (29). Check to
make sure the Miter Guide slides freely to the front and rear of the Wet Tile Saw.
(See Figure E.)
MITER GUIDE
(24)
MITER GUIDE SLIDING TRACK
(29)
FENCE
(11)
RIGHT
CUTTING TABLE
(10)
OPERATING INSTRUCTIONS
2. Raise the Left Cutting Table (26). Then fill the reservoir with water to a level of
1-1/2” deep. Do not overfill or allow the Wet Tile Saw to run dry. Then, close the
Left Cutting Table. (See Figure F, next page.)
1. The Power Cord (17) is stored underneath the Wet Tile Saw. Take out the Power
Cord, but DO NOT plug it into an electrical outlet.
Check Blade Guard for proper upward/downward movement before each use.
Do not operate the Wet Tile Saw if the Blade Guard does not move freely. Never
clamp or tie the Blade Guard into the upward position.
FIGURE E