Filter
Top Products
SKU 91511 PAGE 15
FIGURE H
RIGHT CUTTING TABLE
(10)
WORKPIECE
(NOT INCLUDED)
POWER
SWITCH
(21)
STAND
(0° to 60°) and tighten the Lock Knob to lock the Miter Guide in place.
(See Figure I.)
3. Place the workpiece flush against the Miter Guide (24). Turn the Power Switch
(21) toits “ON” position, and allow the Saw Blade (6) to spin up to full speed.
Then, slowly and carefully push the workpiece into the Saw Blade until the cut is
completed. (See Figure I.)
4. Once the cut is completed turn the Power Switch (21) to its “OFF” position, and
allow the Saw Blade (6) to come to a complete stop on its own. Then remove the
workpiece, and unplug the Power Cord (17) from its electrical outlet.
(See Figure I.)
MITER GUIDE
(24)
WORKPIECE
(NOT INCLUDED)
POWER SWITCH
(21)
FIGURE I