Filter
Top Products
SKU 93218 For technical questions, please call 1-800-444-3353. Page 6
9. Never leave the Masonry Saw unattended when it is plugged into an
electrical outlet. Turn off the tool, and unplug it from its electrical outlet before
leaving.
10. Do not use carbide-tipped saw blades, wood saw blades, or any kind of saw
blade except a diamond-tipped saw blade. Do not cut dry with saw blades
marked “Use Wet”.
11. Always use saw blades with a 10” diameter, 7/8” round arbor hole, and rated
at 5200 RPM or greater. Saw Blades that do not match the mounting hardware
of the Masonry Saw or that are rated less than the required minimum RPM will run
eccentrically causing loss of control or may fly off the Saw.
12. Do not handle the Power Switch with wet hands.
13. Make sure the Masonry Saw is located on a flat, level, sturdy surface capable
of supporting the weight of the Saw and workpieces.
14. Use the Masonry Saw only for cutting cinder block, slump stone block, wall
brick, paver brick, concrete block and cylinders, roofing tile, marble, granite,
decorative rock or almost any other nonferrous material with a maximum
thickness of 3-1/2”.
15. Do not use the Masonry Saw for cutting metals or for cutting curves. This
will cause the Saw Blade to break and/or reduce its service life.
16. Keep all electrical connections dry and off the ground.
17. Make sure the Table of the Masonry Saw and surrounding area are clear with
the exception of the masonry to be cut.
18. Before using the Masonry Saw, check to make sure the Saw Blade is
properly mounted on the Saw Spindle. Make sure the Saw Blade is balanced,
and is not cracked or bent.
19. Industrial applications must follow OSHA guidelines.
20. Never stand on the Masonry Saw. Serious injury could result if the Masonry
Saw is tipped or if the rotating Saw Blade is accidently contacted.
21. Never attempt to cut more than one workpiece at a time.
22. Never attempt to cut freehand. Make sure the masonry to be cut is pressed
firmly against the Table.
23. When cutting a large workpiece, make sure its entire length is properly
supported. If necessary, use a roller stand (not included).